Fabrication files
The above .zip file contains the .dxf’s for the flange, side plate, polycarb holddown polycarb panel (if you want to route it out or similar) and the .step file for the polycarb pull handle. The steel for this build was all laser cut by SendCutSend.
While it’s certainly possible to build a bot, show up to an event, and run it without taking the time to test it’s not the best idea. Similarly, if you’ve got a weapon capable of damaging your opponent, you’ve got a weapon capable of doing real, lasting damage to a person. If you want to test it, you need somewhere safe to do it, and a test box is a great way to protect yourself, protect the other people around you, and test your bot.
With that in mind, I wanted to replace my old bulky test box with something that hit a nice balance of usable space and portability.
The core goals of this design are:
- Small enough to easily go through a door
- Able to be mounted to a wheeled platform
- Big enough for almost any 3lb robot to be tested safely
- Easy to build
- Easy to repair
Goal 1: Small enough to go through a door.
The main structure of the test box is a 26.5″ square frame that can be built to effectively any height. It’s rare to see a door narrower than 30″ so this should fit with room to spare.
Goal 2: Able to be mounted to a wheeled platform.
The hole patterns on the exterior of the flanges will allow the test box to be securely bolted to a frame using a simple hole pattern and #10 hardware.
Goal 3: Big enough for almost any 3lb robot to be tested safely.
With 1/2″ plywood walls the internal usable floorspace is just over 23″ square. Only the largest of the large in the 3lb class can’t fit that footprint.
Goal 4: Easy to build.
The main frame design uses two main parts, a flange and a side plate at qty. 8 each, made from laser cut mild steel. These components key together to aid in fixturing for welding and provide easy attachment points for wall and floor panels. Additionally, the top polycarbonate panel is retained by bolt on flanges and a pin lock to allow a simple rectangle of polycarb to used without any drilling required. The dimensions also allow for 2′ square 15/32″ thick plywood project panels from any local hardware store to be used for the walls and floor with little to no modification required. Similarly, the polycarbonate retainer height can be easily adjusted via 5/16″ OD spacers sized for #10 bolts. For mine I added adhesive backed felt pads to help with sliding the panel in and out. With sufficiently stiff polycarb panels you likely can slide the panel straight back with no issue. If you notice sagging then a small bonded tab that lifts the edge of the panel as it slides in will make closing the test box easy.
Goal 5: Easy to repair
The mild steel frame, easy to swap hardware, and use of commercially available plywood panels means that there’s typically a quick, easy repair option for almost any kind of damage.
For my build I opted to paint much of the plywood, while it’s not necessary it does add a nice finishing touch to the whole thing.
So, what’s left to do? At this point the test box is fully usable. Most of the box is held together using some fairly short #10 wood screws and the pin to lock the polycarb panel in place is McMaster #98320A125 if you want to track down the same part.